Replacement Procedures
4.8 Optical disk drive
NOTE: Do not apply excessive force to the top of an optical disk drive.
Do not touch the shaded portion of the figure below, when the drive is removed
or installed.
Remove an optical disk drive
The following describes the procedure of removing an optical disk drive (See Figure 4-12 to
4-15).
1. Remove the following screw of wireless cover securing Memory Module Cover and
remove it.
• 2.5 x 4.0B BIND screw x3
2. Remove the following screw of optical disk drive BKT screw.
• 2.5 x 4.0B BIND screw x1
3. Remove the following screw of side bracket.
• 2.0 x 3.0B BIND screw x3
Memory
Module Cove
Figure 4-12Remove Memory Module Cover
Satellite M300 and Satellite Pro M300 Maintenance Manual (960-Q08)
4-27
To Next Page
Loading...
