Replacement Procedures
4.14 CPU
Remove the CPU heat sink
The following describes the procedure of removing the CPU heat sink (See Figure 4-27).
1. Disconnect the Heat sink cable from the connector on the system board
2. Remove the following screws securing the heat sink holder along 1 to 6.
• M2.0×3.0 Special Spring screw x3
NOTE: When removing the heat sink holder, be sure to remove the screws in the reverse
order of the number marked on the holder.
3. Remove the CPU heat sink.
M2.0×3.0 3 Special Spring screws
Figure 4-27 Remove the CPU heat sink
Satellite M300 and Satellite Pro M300 Maintenance Manual (960-Q08)
46
To Next Page
Loading...
