Replacement Procedures
4
4.9 Top assembly
Remove the top assembly
The following describes the procedure of removing the cover assembly (See Figure 4-16 to
4-17).
1. Turn over the computer.
2. Remove the following screws securing the cover assembly from the back and bottom
of computer.
• M2.0×6.0 BIND screw Back x5
• M2.5×10 BIND screw Back x6
• M2.5×4.0 BIND screw Back x2
• M2.0×3.0 FLAT BIND screw Back x3
Figure 4-16 remove the screws (back)
Satellite M300 and Satellite Pro M300 Maintenance Manual (960-Q08)
4-30
To Next Page
Loading...
