T1000 Series UPS 1000-3000VA Installation and Operation Manual – 94086-001 30
14 USER’S GUIDE TO OPERATIONS
Necessary information for operation of the unit is covered in this chapter. Normally the
UPS runs automatically, but on those few occasions such as just after installation, all the
starting and shutting down procedures are described herein.
14.1 START UP AND SHUT DOWN THE UPS
Start up the UPS
Ensure that installation was correct and successful and that the input power cable
is connected to a well-grounded outlet.
To start the UPS press and hold the button on the front panel for about 3
seconds.
The UPS should now start its inspection of: internal functions, main
synchronization and inverter startup. Then power should start to be supplied via
the outlets.
During this inspection, the LCD will display “Ready on”. The LED shall light up
when output power has commenced and the LCD will display “Line mode”.
Switch on the loads.
Shut down the UPS
Shut down and turn off all the loads.
Press and hold the button on the front panel for five seconds. The alarm will
sound and the UPS will shut down.
The LCD will display UPS OFF for a few seconds.
In emergency situations, the EPO located on the back of the unit should be used.
14.2 BUTTON OPERATION
Please note the three operating buttons on the front panel:
1. “ ” is a ON/ OFF button :
(a). Press and hold the button (at least 3 seconds) to turn on the UPS.
(b). When UPS is working, press and hold the button (at least 5 seconds) to turn off
the UPS.
2. “ ” is the Enter button. Use this button to check content of UPS using the method
listed below:
(a). Press and hold the button (at least 2 seconds) to check content of UPS. Each
content can be displayed by pressing at once, and it has fifteen kinds of function to be
checked.
(b). If not pressed within 10 seconds, it will return to original status.
3. “ ” is a Function button . Each function can be enabled by pressing this button.
To Next Page
Loading...
