T1000 Series UPS 1000-3000VA Installation and Operation Manual ā 94086-001 31
(a). Press and hold the button (at least 2 seconds) to choose the function you want.
Each content can be displayed by pressing at once, and it has fourteen kinds of
functions to be checked.
(b). After choosing the function, push the button to enter the function that you want.
(c). Push the button to choose other function again.
(d). Push the button to enable your function.
(e). Push the button to confirm and enable your function.
(f). If not pressed within 10 seconds, it will return to original status.
14.3 CONTROL PANEL FUNCTIONS
Operation of the UPS is indicated on the monitor panel with five LED indicators and an
LCD screen. This display is also capable of alerting the user with audible alarms.
ON/ This green LED is lit when UPS has been turned on.
ON-LINE/ When the UPS is in normal or static bypass modes, there is
voltage at the output terminals and this LED will light up in green.
ON-BAT/ While operating in battery mode.
BYPASS/ While operating in bypass mode, this LED will light up in yellow.
FAULT/ If any internal error occurs in the UPS, this LED will light up in
red and sound an audible alarm. Press any of the buttons on the front panel to turn off
the alarm.
Status of the UPS, measurements and alarms are all displayed on the LCD screen.
To Next Page
Loading...
