T2150 Series
Installing the Top Cover, Display assembly, and Speaker
To install the T2150 series top cover, follow the steps below and refer to figures 4-15 to 4-17.
1. Seat the top cover with display assembly (figure 4-17).
2. Connect the display sensor switch cable to PJ11 on the system board (figure
4-17).
3. Connect the display cable to PJ17 on the system board (figure 4-17).
4. Begin at the back and snap the top cover into place (figure 4-17).
5. Secure the two M2.5x8 silver screws on the top cover (figure 4-16).
6. Secure the four flat-head M2.5x6 screws on the battery pack cover (figure 4-16).
7. Connect the AccuPoint cable to PJ13 on the system board and press in on the
hinge on each side to secure the palm rest (figure 4-16).
8. Close the display and turn the computer over so the back faces you.
9. Secure the three M2.5x8 silver screws on the bottom of the computer (figure
4-15).
10. Install the hard disk drive, keyboard, optional memory module, optional PCMCIA
card, and battery pack as described in sections 4.6 back through 4.2.
To Next Page
Loading...
