T2150 Series
Installing the Display Mask
To install the T2150 series display mask, follow the steps below and refer to figure 4-22.
1. Set the display mask in place and secure the latches beginning with the display
supports (figure 4-22).
2. Continue along the bottom of the display (three latches), along the sides (four
latches), and across the top (six latches) (figure 4-22).
3. Secure the display mask with two M2.5x6 screws at the display hinges (figure
4-22).
4. Attach the two rubber seals at each display hinge to cover the screws (figure
4-22).
5. Install the optional PCMCIA card, optional memory card, and battery pack as
described in sections 4.4 back through 4.2.
To Next Page
Loading...
