Toshiba TC-net 100 Installation And Wiring Manual

6F8C0942 43
Chapter 7 At the End of
Wiring
After cabling is finished, check the following and take the necessary steps for protection
from dust.
• Check the cable numbers and connector numbers that they agree with those shown in
the drawings.
• Check the connectors and terminals that their screws are not loose.
• Check the shielded cables that they have been properly processed.
• Check the cables that they are securely clamped to stay steady.
• Check the terminal units and cables that they are free of dust, lint, screws, etc.
• Check the cable holes in the ducts and pits that they are closed with putty or the like to
prevent dust from entering.
In cases where power will not be switched on for a few days after the completion of
cabling, maintain the ambient conditions specified of the place where the devices are
stored, and cover them with vinyl or cloth sheets, while keeping the place ventilated to
protect them from dust.

Toshiba TC-net 100 Specifications

General

Brand	Toshiba
Model	TC-net 100
Category	Network Hardware
Language	English