Toshiba TC-net 100 - 5.2. Dual State Management

6F8C0942 57
D
List of Parts
TC-net 100 transmission parts are shown below.
Relay Connector Unit UCNE1 (Drop-Trunk cable conversion
unit)
This unit is used to connect a drop cable(UTP cable) to a trunk cable(STP cable).
Figure D-1 Relay Connector Unit
SC-SC connector connection unit UCNS1
This unit is used to connect a optical fiber cord(MT-RJ/SC fiber cord) to a optical fiber
cable(with one side at SC connector).
Figure D-2 SC-SC connector connection unit
Ferrite Core Clamp
Attach it to the TC-net 100 module end of the drop cable to reduce radiation from the
cable.
Figure D-3 Ferrite Core
ȅǛȈȌǖǰǒǢ
DžǣǺǢ
中継コネクタユニットで 1 点設置をする場合は、アダプタ
のネジをゆるめて、ラグ端子を取り付け、設置線を出して
ください。
Modular connector
adaptor
To drop cable
Grounding wire (2 mm
2
or more)
To trunk cable