6F8C1406 19
3.2 Network Parameter Setting
3
Max length between nodes: Maximum inter-node distance. (1km - 8km: 1km unit)
Set 8, in case of the maximum node distance is less than
8km.
Max repeater connections: Maximum repeater steps, (1 - 3:1 increment).
Set 3, in case of the maximum repeater steps is less than 3
steps.
Note: Scan cycle higt speed, Scan cycle medium speed, Scan cycle low speed, Max
length between nodes and Max repeater connections parameter set the same
value by the whole system.
After registering the above, execute [File (F)] and [Write (W)].
Then, close the parameter menu, return to [Hardware Configuration] on the Configuration
Editor menu, and execute [File (F)] and [Save(S)].
Open the parameter menu, and download the registered parameters to the hub unit.
To download, display parameter information, and execute [File (F)] and [Download (D)].
To Next Page
Loading...
