This menu shows placement status and other settings.
Sets projection mode in accordance with Placement Style.
The factory default setting.
When you select this function, the projector
reverses the image so you can project behind a translucent
Set the timer to wait for the power to be turned off after signal input
Set whether the input with signals is only selected or not.
Sets the cooling fan speed.
Resets all adjustments and settings to their factory settings.
, the screen becomes a little darker, but the cooling fan noise gets
increases the cooling fan speed. Set this option to use the projector,
for example, at high altitude (over 1,500 meters above sea level).
Using the menu (Continued)
To Next Page
Loading...
