Toshiba TDP-P8 - Displaying Information (Status Display)

34
Displaying Information (Status display)
This displays information about the input signal, lamp use time, etc.
“Yes”: displayed, “No”: not displayed
Using the menu (Continued)
Item
Description
Computer
Y/P
B
/P
R
Video
S-video
Input
Input source name
Yes
Yes
Yes
Mode name
RGB input mode
[Note 1]
Yes
No
No
H-resolution
Horizontal resolution (in dots)
Yes
No
No
V-resolution
Vertical resolution (in dots)
Yes
No
No
H-frequency
Horizontal sync frequency
Yes
No
No
V-frequency
Vertical sync frequency
[Note 2]
Yes
No
No
Sync
Sync signal polarity
[Note 3]
Yes
No
No
Signal format
Y/P
B
/P
R
signal format
No
Yes
No
Video mode
Color method of video signal
No
No
Yes
Lamp time
Time of lamp use
[Note 4]
Yes
Yes
Yes
Lamp reset count
The count for lamp replacement
Yes
Yes
Yes
Total time
The total time that this projector is used
Yes
Yes
Yes
Version
Firmware version
[Note 5]
Yes
Yes
Yes
Notes
1:
The mode of supported RGB signals
p.
3
9
is shown.
2:
Same as the refresh rate of the computer signal.
3:
Sync signal polarity shown as P (positive) or N (negative) for [H/V].
4:
Displays
[Lamp time]
as a measure of when the lamp should be replaced. (Cannot be used as a
counter of guaranteed lamp time.) When the displayed time approaches 2,000 hours, consult with a
store about getting a TLPLP8 replacement lamp (sold separately) prepared.
5:
[Version]
shows the version of the projector’s internal control program. This version is referred to for
customer service, etc.
Note
•
The displayed information will not be refreshed if the status changes. To refresh the
information, dismiss the display, then display it again.