69
Connecting Other External Devices
Adding memory
5.375 x 8.375 ver 2.3
Static electricity can damage the memory module. Before you
handle the module, touch a grounded metal surface to
discharge any static electricity you may have built up.
To avoid damaging the memory module, be careful not to
touch its pin connector on the side you insert into the
computer.
9 Remove the new memory module from its antistatic
packaging.
10 Holding the memory module at an angle by its edges so
that the gold connector bar faces the slot, fit the module
into the socket.
11 Gently press down on the memory module until the clips
snap into place.
Do not force the module into position. The memory module
should be level when secured in place.
Inserting the sample memory module into the secondary slot
Avoid touching the connectors on the memory module or on
the computer. Grease or dust on the connectors may cause
memory access problems.
12 Replace the cover slot and the screw.
To Next Page
Loading...
