Toshiba TOSVERT VF-S15 series User Manual

E6581913
49
7.1. Baud rate ( f800 ), Parity ( f801 )
Communication baud rate and parity bit should be uniform inside the same network.
This parameter is validated by resetting the power supply.
7.2. Inverter number ( f802 )
This parameter sets individual numbers with the inverters.
Inverter numbers should not be duplicated inside the same network.
Receiving data will be canceled if inverter numbers specified in individual communication and set by
a parameter do not match.
This parameter is validated from the communication after change
Data range: 0 to 247 (Initial value: 0)
Parameters can be selected between 0 and 247. Note that the communication protocols limit
inverter numbers as follows:
● Toshiba inverter protocol ASCII mode: 0 to 99
● Toshiba inverter protocol Binary mode: 0 to 63
● Modbus RTU protocol: 0 to 247 (0: Broadcast communication)
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com

Toshiba TOSVERT VF-S15 series Specifications

General

Series	VF-S15
Category	Inverter
Control Method	V/f control, Sensorless vector control
Overload Capacity	150% for 60 seconds
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheat, Short Circuit
Communication Options	Modbus
Braking Unit	Built-in
Power Rating	0.4 kW to 15 kW
Input Voltage	Single-phase 200 to 240V, Three-phase 200 to 240V, 380 to 480V
Cooling Method	Fan cooling