10
Buttons on remote controller
ON/OFF
BUTTON
Press this button to turn on or turn off the air conditioner.
+ /
–
BUTTON
Press "+" or "-" button once to increase or decrease set temperature
by 1°F (°C).
COOL BUTTON
Press this button and then the air conditioner will operate in cool mode.
DRY BUTTON
Press this button and then the air conditioner will operate in dry mode.
FAN ONLY BUTTON
Press this button and then the air conditioner will operate in fan mode.
It only blows wind, no cooling.
FAN SPEED BUTTON
Press this button to set the fan speed at Auto, Low, Med or High.
NOTE: Only low fan speed is available under Dry mode.
Replacement of batteries in
remote controller
1. Press the back side of remote controller marked with
"=" as shown in the fig, and then push out the cover of
battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure
the position of "+" polar and "-" polar are correct.
3. Reinstall the cover of battery box.
NOTICE
•
During operation, point the remote control signal sender at the receiving window on indoor
unit.
•
The distance between signal sender and receiving window should be no more than 8m (26.25'),
and there should be no obstacles between them.
•
Signal may be interfered easily in the room where there is fluorescent lamp or wireless
telephone; remote controller should be close to indoor unit during operation.
•
Replace new batteries of the same model when replacement is required.
•
When you don't use remote controller for a long time, please take out the batteries.
•
If the display on remote controller is fuzzy or there's no display, please replace batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable (ni-cad, ni-mh, etc.) batteries.
Signal sender
Battery
Reinstall
Remove
Cover of battery box
To Next Page
Loading...
Need help?
General
