12
Clean heat discharge pipe
Remove the heat discharge pipe from air conditioner, clean and dry it , and then reinstall it. (For
the method of installation and removal, please refer to the instruction for "Installation of heat
discharge pipe").
Checking before use-season
1. Check whether air inlets and air outlets are blocked.
2. Check whether plug and socket are in good condition.
3. Check whether filter is clean.
4. Check whether batteries are installed in remote controller.
5. Check whether joint, window bracket and heat discharge pipe are installed tightly.
6. Check whether heat discharge pipe is damaged.
Checking after use-season
1. Disconnect power supply.
2. Clean filter and outer case.
3. Remove dust and sundries on the air conditioner.
4. Eliminate accumulated water in chassis (refer to the section of "Removing collected water" for
details).
5. Check whether window bracket is damaged or not. If yes, please contact dealer.
Long-time storage
If you don't use the air conditioner for a long time, please maintain it by following steps for good
performance:
• Make sure there's no accumulated water in chassis and the heat discharge pipe is disassembled.
• Pull out the plug and wrap the power cord.
• Clean the air conditioner and pack it well to prevent dust.
Notice for recovery
• Many packing materials are recyclable materials. Please deal with them through local recycle
bin.
• If you want to throw away the air conditioner, please contact local division or consultant service
center for the correct disposal method.
To Next Page
Loading...
Need help?
General
