User’s Guide | TOTEM 10 - TOTEM 20
28 of 30
Electric power generated on L2phase line
Electric power generated on L3 phase line
Voltage on L1 phase line
Voltage on L2 phase line
Voltage on L3 phase line
Current generated on L1 phase line
Current generated on L2 phase line
Current generated on L3 phase line
Mains frequency
Power factor (power factor correction)
Magneti Marelli diagnostic code
Water temperature at TOTEM inlet
Water temperature at TOTEM outlet
Temperature inside the unit
Grid-connected working hours
Maintenance interval down-counter
Maintenance Interval Incremental Index
Machine Status and Step
Machine Active Alarm Vector
B.
Remote Connection
Remote connection allows to access one or more units’ historical data log. Once a
day a data packet containing the operating data recorded every 15 seconds,
alongside alarm history, if any, is sent by the TOTEM to cloud.
To set up a remote connection users just have to open any web browser and enter
the following address: http://totem.whiteqube.it . They will be redirected to the login
page, where username and password must be entered. In addition to viewing
historical data, it is also possible to set up a real-time connection with the unit, so as
to check unit status and/or modify the operating parameters. The real-time
connection maximum duration is 15 minutes. The use of real-time connection is
subject to payment of a fee according to the subscription agreement terms.
To Next Page
Loading...