Remote Control Operation
• This remote control uses 2 AAA batteries (not included).
• To improve operation of the remote control, aim the remote control at the front of the fireplace.
• DO NOT PRESS the buttons too quickly. Give the unit time to respond to each command.
• NOTICE: NEVER dispose of batteries in fire. Failure to observe this precaution may result in
• an explosion. Dispose of batteries at your local hazardous material processing center.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature, the heater will automatically TURN OFF. To reset, please do the following:
1. Unplug the power cord from the outlet.
2. Turn ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes for fireplace to cool down.
3. Inspect the fireplace to make sure no vents are blocked or clogged with dust or lint.
3. If they are, use a vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If the problem continues, have your outlet and wiring inspected by a professional.
5. If the outlet is OK, please contact our customer support department at 800-215-1990.
28
Touchstone Home Products
Operating Your Fireplace
To Next Page
Loading...
