2 of 12
FCC Notice
This equipment has been tested and found to comply with limits for a
Class A digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful
interference in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Note: Unauthorized modification of the receiver or radio remote control
could void the user's authority to operate this equipment.
This product complies with the Canadian ICES-003 Class A specification.
Do not use this apparatus near water of moisture—Do not
use this product near a bathtub, washbowl, kitchen sink,
laundry tub, in a wet basement, near a swimming pool, or
anywhere else that water or moisture are present.
Clean only with a dry cloth—and as directed in this
document. Unplug this product from the wall outlet before
cleaning.
Do not block any ventilation opening. Install in accordance
with the manufacturer’s instructions—To ensure reliable
operation of the product and to protect it from overheating, put
the product in a position and location that will not interfere
with its proper ventilation. For example, do not place the
product on a bed, sofa, or similar surface that may block the
ventilation openings. Do not put it in a built-in system, such as
a bookcase or a cabinet that may keep air from flowing
through it ventilation openings.
Do not let objects or liquids enter the product—as they may
touch dangerous voltage points or short-out parts that could
result in a fire or electric shock.
Protect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
Use only attachments and accessories specified by the
manufacturer.
Refer all services to qualified service personnel. Services is
required when the apparatus has been damaged in any way:
such as power-supply cord or plug is damaged; liquid has
been spilled or objects have fallen into the apparatus; the
apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
To disconnect this apparatus you must unplug it from the
wall outlet, therefore ensure during installation that the plug
will be accessible after installation to facilitate
disconnecting it from the wall outlet. or equivalent.
To prevent risk of fire or electric shock, avoid overloading
wall outlets, extension cords, integral convenience
receptacles.
To Next Page
Loading...
