’03 4Runner_U (L/O 0211)
151
2003 4RUNNER from Oct. ’02 Prod. (OM35804U)
3. Push the “DAC” switch to turn the
system on. The downhill assist con-
trol system indicator light on the in-
strument panel will come on.
Full–time four–wheel drive models—If the
downhill assist control system indicator
light flashes, the selector lever may be in
“N” or the four–wheel drive control switch
knob may be in the “H4” position.
If the indicator light does not come on
when the switch is pushed, contact your
Toyota dealer.
Multi–mode four–wheel drive models—If
the downhill assist control system indica-
tor light flashes, the selector lever may be
in “N” or the multi–mode control switch
knob may be in the “H2” or “H4” position.
If the indicator light does not come on
when the switch is pushed, contact your
Toyota dealer.
With the vehicle traveling at a speed of
25 km/h (15 mph) or less, release your
foot from the accelerator or brake pedal
to activate the system. The vehicle will
descend the hill at a low speed. While the
system is operating, the slip indicator light
on the instrument panel will flash and the
stop lights and high mounted stoplight will
be lit.
If you push the “DAC” switch to turn the
system off while it is in operation, the
system will stop operating gradually. The
downhill assist control system indicator
light will flash to alert the driver. To con-
tinue driving at a low speed, push the
“DAC” switch to turn the system on.
To Next Page
Loading...
Need help?
General
