EasyManua.ls Logo

Toyota C-HR 2017 - Page 459

Toyota C-HR 2017
812 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
459
4-5. Using the driving support systems
4
Driving
C-HR_OM_Europe_OM10528E
WARNING
The system may not be able position the vehicle in the set location in the
following situations.
The tires are extremely worn or the tire pressure is low
The vehicle is carrying very heavy load
The vehicle is tilted due to having luggage, etc., located on one side of
the vehicle
There are road heaters installed in the parking lot to prevent the road
surface from freezing.
In any other situations when the set position and vehicle position greatly
differ, have the vehicle inspected by any authorized Toyota retailer or
Toyota authorized repairer, or any reliable repairer.
Make sure to observe the following precautions regarding the exit parallel
parking assist mode.
Exit parallel parking assist mode is a function used when departing from a
parallel parking spot. However, this function may not be usable if obsta-
cles or people are detected in front of the vehicle. Only use this function
when departing from a parallel parking spot. In the event that the steering
control operates, either turn the system off using the S-IPA switch or oper-
ate the steering wheel to stop the control.
If exit parallel parking assist mode is mistakenly used in the following situ-
ations, the vehicle may make contact with an obstacle.
The departure function is operated in a direction where an obstacle is
present, but the obstacle is not detected by the side sensors (situations
such as when the vehicle is directly beside a pole).
Observe the following precautions, as the sensors may stop functioning
properly which may lead to an accident.
Do not subject the sensor to strong shocks by hitting it, etc. The sen-
sors may not function properly.
When using a high-pressure washer to wash the vehicle, do not spray
water directly on the sensors. Equipment may not function properly if
subjected to an impact from strong water pressure. If the vehicle
bumper strikes something, equipment may not operate properly due to
a sensor malfunction. Have the vehicle inspected at any authorized
Toyota retailer or Toyota authorized repairer, or any reliable repairer.

Table of Contents

Related product manuals