Toyota C-HR 2017 - Setting Automatic Connection of the Device on or off; Displaying the Device Status; Setting the Automatic Connection Confirmation Display to on or off

535
5-7. “SETUP” menu
5
Audio system
C-HR_OM_Europe_OM10528E
If “BT power” is set to on, the registered device will be connected
automatically when the engine switch is turned to the “ACC” position
(vehicles without smart entry & start system) or ACCESSORY mode
(vehicles with smart entry & start system).
Select “BT power” using the tune/scroll knob. (P. 528)
Select “ON” or “OFF” using the knob.
Select “Bluetooth
* info” using the tune/scroll knob. (P. 528)
● Displaying the device name
Select “Device name” using the tune/scroll knob.
● Displaying the device address
Select “Device address” using the tune/scroll knob.
*: Bluetooth is a registered trademark of Bluetooth SIG, Inc.
If the “Display setting” is set to on, the portable player connection sta-
tus will be displayed when the engine switch is turned to the “ACC” or
“ON” position (vehicles without smart entry & start system), or
ACCESSORY or IGNITION ON mode (vehicles with smart entry &
start system).
Select “Display setting” using the tune/scroll knob. (P. 528)
Select “ON” or “OFF” using the knob.
Setting automatic connection of the device on or off
Displaying the device status
Setting the automatic connection confirmation display to on or off
1
2
1
2