To Next PageTo Next Page
Need help?Do you have a question about the Toyota CAMRY PT949-08210 and is the answer not in the manual?
General| SKU | PT949-08210 |
|---|---|
| Category | Dash Cameras |
| Brand | Toyota |
| Placement | Windshield |
| Recording Resolution | 1080p |
| Night Vision | Yes |
| Features | Loop Recording, G-Sensor |
| Storage | MicroSD card |
| Power Source | Vehicle's 12V power outlet |
Tools for protecting the vehicle interior.
Specific tools for installation tasks.
Tools required for the installation process.
Cleaning agents required for installation.
Lists items included in the Dashcam kit.
Lists items included in the Y-Harness kit.
Order of accessory installation.
Safeguard the vehicle's fender before starting.
Warning about hot engine components and coolant.
Disconnect the vehicle's 12V battery negative terminal.
Caution against touching high voltage systems on hybrids.
Verify Dashcam kits for missing items or damage.
Confirm the correct camera angle using reference lines.
Protect vehicle seats, dashboard, and console.
Temperature requirement and template selection.
Clean the windshield area for mounting.
Align and affix the base plate to the windshield.
Align paper template to TSS cover and affix with tape.
Stick mounting plate using reference lines on template.
Remove template and clean residue.
Twist and pull sun visor hooks to release.
Release tabs and pull out the base using pliers.
Pull down, slide forward, and unhook the console.
Disconnect wire harness and place console safely.
Inspect and replace damaged console clips.
Rotate mirror to improve access to TSS cover sides.
Move TSS cover down towards wiper cowl for access.
Detach smaller inset cover around mirror mount.
Slide main cover down and away from the base.
Disconnect the 10-pin mirror power harness.
Install Y-harness between mirror and vehicle wire harness.
Apply foam tape to insulate connectors from rattles.
Find the notch in the front edge of the headliner.
Thread Dash Cam pigtail into headliner via notch.
Guide Dashcam harness to the open Map Light Console.
Connect the Dashcam pigtail to the fitted Y-harness.
Apply foam tape to insulate connectors from rattles.
Push cover up towards headliner to engage clips.
Hook front hooks and push mirror cover to engage clips.
Note regarding removal of Hang Tag by end user.
Remove semi-transparent blue film from camera lens.
Observe T-hook shape for locking onto base plate.
Slide Dashcam onto T-hooks and engage clip.
Hook Dashcam wire extension cover into headliner edge.
Swing Dashcam unit towards base plate, check alignment.
Push Dashcam towards windshield for correct T-hook engagement.
Slide Dashcam down to engage clip and secure.
Use foam tape to protect connectors and minimize rattles.
Bundle against existing harnesses at map light opening.
Bundle Dashcam pigtails against harnesses, avoid obstruction.
Verify console connection is free and not obstructed.
Reconnect console harness, test lights and controls.
Inspect console clips for condition and presence.
Insert tabs and rotate console upwards to lock clips.
Snap clip bases securely into map light console.
Insert and rotate visor clips clockwise to lock.
Reconnect the vehicle's negative battery cable.
Torque negative battery cable to 5.4 N•m (48 in•lbsf).
Caution: Do not touch the positive terminal with any tool.
Place Owner's Manual/Quick Start Guide in glove box.
Adjust angle if it does not match vehicle intention.
Use Allen key to turn screws counter-clockwise to loosen.
Raise or lower camera angle to see two recessed rib lines.
Retighten screws and reconfirm rib lines for camera position.
Verify parts, vehicle startup, and LED functionality.
Confirm standard lighting, roof console, and mirror functions.
Inspect for damage and ensure all templates/tools are removed.
