To Next PageTo Next Page
Need help?Do you have a question about the Toyota PT949-34220 and is the answer not in the manual?
General| Brand | Toyota |
|---|---|
| Model | PT949-34220 |
| Category | Dash Cameras |
| Language | English |
The primary dashcam unit for recording video.
Includes a holder and a 16 GB SD card for storage.
Plate for mounting the dashcam to the windshield with adhesive tape.
Includes cable ties for organizing wiring.
Items for protecting vehicle interior and person during installation.
Specific tools recommended for installation, like the Install Aid.
Standard tools like sockets and wrenches needed for the job.
Approved cleaner for maintaining windshield clarity.
Protect fender/bumper and paintwork before starting battery disconnection.
Loosen the 10 mm nut on the negative terminal and keep it clear.
Caution about hot engine parts and high voltage systems on Hybrid models.
Verify all dashcam kit components are present and undamaged.
Check the camera's initial angle using visible recessed lines.
Apply protection to seats, dashboard, and center console.
Ensure windshield is at least 50°F (10°C) before installation.
Use 3D hard template or paper template for precise alignment.
Clean windshield, align plate using template, and press firmly.
Twist and pull visor hooks to release them from the map light console.
Pull console down, release clips, slide forward/down to detach.
Disconnect the wire harness from the removed roof console.
Feed dashcam pigtail through headliner indentation from windshield edge.
Pull wire length to console, locate pre-wire harness, and connect.
Connect harness, secure clip, use foam tape, and zip tie excess.
Note: Hang tag is for end-user removal; do not remove it during installation.
Remove the semi-transparent blue film from the camera lens.
Align T-hooks, slide dashcam onto base plate, and engage clip.
Protect connectors with foam tape to prevent potential rattles.
Secure dashcam harnesses, orient zip tie block for noise prevention.
Ensure connection is free and harnesses do not obstruct console.
Reconnect harness, align tabs, and secure console clips.
Reinsert and rotate sun visor clip to lock into place.
Reconnect negative battery cable and torque to specification.
Use Allen key to loosen screws and adjust camera view angle.
Confirm correct angle by checking for two recessed rib lines.
Retighten locking screws after adjustment to secure the camera.
Verify parts, vehicle startup, power LEDs, and lens protector removal.
Confirm standard lighting, roof console, EC mirror, and TPMS functions.
Ensure no damage occurred and all templates/tools are removed.
