Corolla (E12-A + E12-D) TOYOTA GENUINE AUDIO
Corolla (RHD) - 205-04
PRECAUTIONS
• Be sure to disconnect the negative (-) lead from the battery ter-
minals.
• Do not pinch the rear wiring or harness in the tightened part.
• When passing the wires through the bulkhead or other panels,
use a grommet to ensure waterproofing.
• Protect the wiring using tape when it is passed through a hole.
• When disconnecting the connectors, be sure to grip the con-
nector body. Do not tug on the wiring.
• Do not forcibly pull any car wiring harness. Rough tugging may
result in opened connections, or a broken wire or harness.
• Confirm that lamps, horn, wiper and other car accessories operate
normally.
• Protect your car using wing covers, seat and so on.
• Use the correct tool when tightening bolts or nuts.
• Before drilling a hole, check that the rear of the mounting wall
is clear.
• Be sure to firmly tighten connectors and terminals.
• Before connecting the power wiring to the battery, check the
wiring connections, harness, etc. to see that they are properly
secured.
• Check body and trim near area of installation to be certain no
dirt or scratches resulted from the installation.
PLEASE READ THOROUGHLY THESE PRECAUTIONS
BEFORE THE INSTALLATION
waterproof - O.K. !!
Grommet
Stop it !
Taping
Insert
completely
To Next Page
Loading...
Need help?
General
