Need help?Do you have a question about the Toyota Corolla E12-A and is the answer not in the manual?
General| Brand | Toyota |
|---|---|
| Model | Corolla E12-A |
| Category | Car Receiver |
| Language | English |
Copying, cutting, and marking templates onto the cluster panel for modification.
Detailed marking of the cluster panel's right, left, and lower sides using templates and a ruler.
Performing cuts on the lower cluster panel at marked points and on ribs.
Cutting marked areas at the corners and sides of the lower cluster panel.
Cutting the last marked area and fitting the new panel onto the cluster.
Cutting the carpet, stripping insulation, and attaching spacers and tapes to the base bracket.
Routing tweeter harness behind weather seal and splicing wires on the right side.
Locating the LH connector, and splicing the red/black wire of the tweeter.
Fitting the subwoofer to base brackets using nuts and caps, and final checks.
To Next Page