RUBBER EXTRUSION
TRIM LINE
Diagram #4
4. Remove the rubber extrusion fitted to the top front edge of the ute liner. Draw a straight line along the front edge of
the ute liner, using the steps on each side as a marking point as shown (approximately 30-40mm to be cut down).
The rubber extrusion should be reused. See Dia #4.
Diagram #5
Hard Tonneau Cover, A-Deck
Accessory Part No. PZQ70-89870
TC0403c
Page 6 of 34Accessory Part No. PZQ70-89870ISSUE 4: 09/10/18
DRILL Ø35mm HOLE
PAPER TEMPLATE
HOLE FOR ELECTRICAL HARNESS IN TUB
Ø35mm
5. Cut out the paper template from page 34 of this fitting instruction. Place the template in the front left corner of the
uteliner as shown. Mark and drill 35mm hole in the uteliner for the lamp harness. See Dia #5.
6. Cut out and adhere the supplied Template (1) from page 33, to the LHS front inner tub panel area (2) using tape.
Mark Ø3mm on the drill (3) using a drill stop (4) to a depth of 10mm. Drill a pilot hole through the template crosshair
centre (5). Remove and discard the template (1). Using a stepped drill bit, drill out the previously drilled pilot hole to
Ø30mm. See Dia #6.
Diagram #6
10mm
4
3
1
2
5
To Next Page
Loading...
