62
2-1. Instrument cluster
Displays warning messages in case of a malfunction (P.360)
Clock (P. 63)
Speedometer
Fuel gauge
Displays the quantity of fuel remaining in the tank
Odometer and trip meter display (P.6 3)
Shift position display (P.158)
Outside temperature
Displays the outside temperature within the range of -40°C (-40°F) to 50°C (122°F).
Low outside temperature indicator comes on when the ambient temperature is 3°C
(37°F) or lower.
Engine coolant temperature gauge
Displays the engine coolant temperature
■
The meters and display illuminate
when
The engine switch is in ON.
■
Outside temperature display
●
In the following situations, the correct
outside temperature may not be dis-
played, or the display may take longer
than normal to change:
• When stopped, or driving at low
speeds (less than 20 km/h [12 mph])
• When the outside temperature has
changed suddenly (at the
entrance/exit of a garage, tunnel, etc.)
●
When “--” or “E” is displayed, the sys-
tem may be malfunctioning. Take your
vehicle to your Toyota dealer.
■
Liquid crystal display
Small spots or light spots may appear
on the display. This phenomenon is
characteristic of liquid crystal displays,
and there is no problem continuing to
use the display.
■
Customization
The meters can be customized on
of the multi-information display. (P. 7 0 ,
79)
■
The information display at low
temperatures
Allow the interior of the vehicle to
warm up before using the liquid crys-
tal information display. At extremely
low temperatures, the information dis-
play monitor may respond slowly, and
display changes may be delayed.
For example, there is a lag between
the driver’s shifting and the new gear
number appearing on the display.
This lag could cause the driver to
downshift again, causing rapid and
excessive engine braking and possi-
bly an accident resulting in death or
injury.
■
To prevent damage to the engine
and its components
●
Do not let the indicator needle of
the tachometer enter the red zone,
which indicates the maximum
engine speed.