82
2-1. Instrument cluster
Driving assist system status display area (P. 84 )
Eco Driving Indicator/Tachometer/Outside temperature (P. 84 )
■
Head-up display will operate when
The engine switch is in ON.
■
When using the head-up display
The head-up display may seem dark or
hard to see when viewed through sun-
glasses, especially polarized sun-
glasses. Adjust the brightness of the
head-up display or remove your sun-
glasses.
■
Outside temperature display
If the outside temperature becomes
approximately 3°C (37°F) or lower, the
low outside temperature indicator will
flash for 10 seconds then the low out-
side temperature indicator and outside
temperature display will turn off. The low
outside temperature indicator will oper-
ate again if the outside temperature
becomes approximately 5°C (41°F) or
more and then decreases to 3°C (37°F)
or lower.
■
Changing settings of the
head-up display
Select on the multi-information
display (P.396) and then .
■
Enabling/disabling the
head-up display
Press to enable/disable the
head-up display.
■
Before using the head-up display
●
Check that the position and bright-
ness of the head-up display image
does not interfere with safe driving.
Incorrect adjustment of the image’s
position or brightness may obstruct
the driver’s view and lead to an
accident, resulting in death or seri-
ous injury.
●
Do not continuously look at the
head-up display while driving as
you may fail to see pedestrians,
objects on the road, etc. ahead of
the vehicle.
■
To prevent damage to compo-
nents
●
Do not place any drinks near the
head-up display projector. If the
projector gets wet, electrical mal-
functions may result.
●
Do not place anything on or put
stickers onto the head-up display
projector. Doing so could interrupt
head-up display indications.
●
Do not touch the inside of the
head-up display projector or thrust
sharp edges or the like into the pro-
jector. Doing so could cause
mechanical malfunctions.
Using the head-up display
To Next Page
Loading...
