Toyota KLUGER 2021 - Page 85

83
2
2-1. Instrument cluster
Vehicle status information and indicators
■ Changing the head-up display
settings
Press and hold to display the
following settings.
 “HUD Brightness/Position”
Select to adjust the brightness and ver-
tical position of the head-up display.
 “HUD Driving Support”
• Tachometer Settings
Blank/Eco Indicator/Tachometer
Select to change the display to blank
(no display)/Eco Driving Indica-
tor/tachometer.
Select to enable/disable the following
items:
• Navigation (if equipped)
• Driving Assist
• Compass (if equipped)
•Audio
 “HUD Rotation”
Select to adjust the angle of the
head-up display.
Press the or switch to adjust
the angle of the head-up display.
■ Enabling/disabling of the head-up
display
If the head-up display is disabled, it will
remain disabled when the engine switch
is turned off then back to ON.
■ Display brightness
The brightness of the head-up display
can be adjusted on of the
multi-information display. Also, it is auto-
matically adjusted according to the
ambient brightness.
■ Automatic adjustment of the
head-up display position (vehicles
with driving position memory)
A desired head-up display position can
be entered to memory and recalled
automatically by the driving position
memory system. (P.11 8)
■ When the battery is disconnected
The customize settings of the head-up
display will be reset.
■ Customization
Some functions can be customized.
(P.396)
WARNING
■ Caution for changing settings of
the head-up display
As the engine needs to be running
while changing the settings of the
head-up display, ensure that the vehi-
cle is parked in a place with adequate
ventilation. In a closed area such as a
garage, exhaust gases including
harmful carbon monoxide (CO) may
collect and enter the vehicle. This
may lead to death or a serious health
hazard.
NOTICE
■ When changing the settings of
the head-up display
To prevent battery discharge, ensure
that the engine is running while the
changing the settings of the head-up
display.