41
CHANGING PRE-COLLISION ALERT TIMING
DISABLING PRE-COLLISION SYSTEM (PCS)
Far
Middle
(default)
Near
(1) Press “ ” switches and select “ ” from the Multi-Information Display (MID).
(2) Press “
” switches and select “ PCS” and then press “ .” The setting
screen is displayed.
(3) Press “
” switches and select “Sensitivity” and then press “ ” to select the
desired setting. Each time it is pressed, the response to the PCS alert timing
changes as shown above.
(4) Press “
” to go back to the menu.
Note: PCS is enabled each time the vehicle is turned on. The system can be
disabled/enabled and the alert timing of the system can be changed. (Alert
timing only, brake operation remains the same.)
(1) Press “
” switches and select “ ” from the Multi-Information Display (MID).
(2) Press “
” switches and select “ PCS” and then press “ .” The setting
screen is displayed.
(3) Press “
” and select “PCS on/off” and then press “ ” to select the desired
setting.
(4) Press “
” to go back to the menu.
Note: The system is enabled each time the vehicle is turned on.
Refer to the Toyota Owner’s Manual for additional information on PCS operation,
settings adjustments, limitations, and precautions before attempting to use it.
OVERVIEWFEATURES & OPERATIONSTOYOTA SAFETY SENSESAFETY & EMERGENCY FEATURES
To Next Page
Loading...
