Toyota RAV4 PHEV 2023 - Page 114

112
2-2. Charging
■ Identification label
Identification labels are attached to the vehicle, AC charging cable and charger to
inform the user of which device they should use.
The meaning of the each identification label is as follows:
Mode 2
A charging method which connects the vehicle to an external
power source through a AC charging cable equipped with a
CCID (Charging Circuit Interrupting Device).
Applies to charging through most household sockets.
Mode 3
A charging method which charges from a charger (such as at a
public charging station) equipped with charging control to
detect electrical leakages. Control to detect electrical leakages
is implemented on the charger side. Therefore, a CCID
(Charging Circuit Interrupting Device) is not equipped to the AC
charging cable.
Not all chargers are equipped with AC charging cables. If there
is no AC charging cable available, use the Mode 3 AC charging
cable equipped to this vehicle. (if equipped)
Identification
label
Supply
type
Standard Configuration
Type of
accessory
Voltage
range
AC EN 62196-2 TYPE 2
Charging
port lid
Charging
connector
≤ 480V RMS
AC EN 62196-2 TYPE 2
Charging
plug
Charger
≤ 480V RMS
DC EN 62196-3 FF
Charging
port lid
Charging
connector
50V to 500V
DC EN 62196-3 AA
Charging
port lid
Charging
connector
50V to 500V
Charging mode Outline
OwnersManuals2.com