118
2-2. Charging
■ Rating
Voltage (Un): 220 V - 240 V ~
Frequency: 50 Hz / 60 Hz 1Φ
Current: 10 A
Residual operating current (IΔn): 6 mA
Ambient temperature: -30°C to 55°C
IP67
■ Routine inspection
Check the following points regularly.
Failure to do so may cause an unex-
pected accident, resulting in death or
serious injury.
● The AC charging cable, plug,
charging connector, CCID
(Charging Circuit Interrupting
Device) etc. have not been dam-
aged.
● The socket has not been damaged.
● The plug can be securely inserted
into the socket.
● The plug does not get extremely hot
during use.
● The tip of the plug has not been
deformed.
● The plug is not dirtied by dust etc.
Remove the plug from the socket
before inspecting it. If any abnormali-
ties are found in the AC charging
cable as a result of the inspection,
immediately stop use and consult any
authorized Toyota retailer or Toyota
authorized repairer, or any reliable
repairer.
■ Maintaining the AC charging
cable
When the AC charging cable is dirty,
first remove the dirt with a hard,
wringed cloth, and then wipe the
cable with a dry cloth.
However, never wash it with water. If
the AC charging cable is washed with
water, fire or electric shock may occur
during charging, possibly resulting in
death or serious injury.
■ When not using the AC charging
cable for a long time
Remove the plug from the socket.
Dust could accumulate on the plug or
in the socket, possibly causing over-
heating which could lead to a fire.
Also, keep the cable in a place free
from moisture.
Appendix (Mode 2 AC charging cable)
To Next Page
Loading...
