136
2-2. Charging
P.133
1 Prepare the AC charging cable.
When using the Mode 2 AC
charging cable
2 Make sure to hold the body of
the plug and insert it firmly into
the socket.
If you have a remote switch, turn it on.
Check that the power indicator on the
CCID (Charging Circuit Interrupting
Device) is illuminated. (If it is not illumi-
nated, refer to P.167)
Use a string, etc. to hang the CCID
(Charging Circuit Interrupting Device)
on a hook or equivalent when a load is
applied to the socket and plug due to
the installation height of the socket.
The CCID (Charging Circuit Interrupting
Device) can be hung by using the hole
in the back. Do not attach the CCID
(Charging Circuit Interrupting Device)
to the wall with screws.
When using the Mode 3 AC
charging cable (if equipped)
2 Remove the cap of the charging
plug and then connect the
charging plug to the charger.
When connecting the charging plug into
the charger, make sure that the identifi-
cation symbols are the same.
Make sure to hold the body of the
charging plug and insert it firmly and
fully into the charger.
Follow the instructions of the charger
for details regarding how to connect the
AC charging cable and how to start
charging. Depending on the charger, it
may be necessary to receive authoriza-
tion to use it. For details, refer to the
● Do not damage the AC charging
inlet cap with a sharp object.
● Do not forcefully pull the AC
charging cable that is caught or
entangled. If the cable is entangled,
disentangle it before using.
● Do not disassemble, repair or mod-
ify the AC charging inlet. When the
AC charging inlet needs to be
repaired, consult any authorized
Toyota retailer or Toyota authorized
repairer, or any reliable repairer.
Charging precautions
When charging
To Next Page
Loading...
