157
2
2-2. Charging
Plug-in hybrid system
procedure (P.153) and display
“Charging Schedule” screen.
2 Press or of the meter
control switches to select
“Charge Now”, and then press
.
Each time is pressed, “Charge
Now” switches between on and off.
Operation on “Closing Display”
screen
1 Turn the power switch off.
The “Closing Display” screen is dis-
played on the multi-information display.
(P.158)
2 Press to set “Charge Now”
to on.
Each time is pressed, “Charge
Now” switches between on and off.
After setting operations are com-
plete, charging starts when the AC
charging cable is connected.
(P.135)
■ Changing “Next Event”
*
*
: When “Charge Now” is set to on or
when using “My Room Mode”
(P.164) etc., it is not possible to
change the registered “Next Event”.
1 Perform step 1 to 5 of the “Reg-
istering the charging schedule”
procedure (P.153) and display
“Charging Schedule” screen.
2 Press or of the meter
control switches to select “Next
Event”, and then press .
The “Next Event” screen will be dis-
played.
3 Press or of the meter
control switches to select “Yes”,
and then press .
The confirmation message will be dis-
played on the screen.
Press , and the “Charging Mode”
screen will be displayed.
Press to return to the previous
screen.
4 Change the desired settings as
described starting from step
8 of
To Next Page
Loading...
