168
2-2. Charging
■ The error warning indicator on the CCID (Charging Circuit Interrupt-
ing Device) flashes.
■ Charging indicator of the charging port does not illuminate, even
though charging connector is connected.
Likely cause Correction procedure
Electrical leakage detection function or
self-diagnostic function operates and
power is cut off
When the voltage is insufficient, the error
warning indicator may flash when there
is noise interference. Perform a reset
and connect to a proper power source.
(P.114)
If charging does not start, immediately
stop charging and contact any authorized
Toyota retailer or Toyota authorized
repairer, or any reliable repairer.
Likely cause Correction procedure
The plug is not properly connected to the
socket
Check whether the plug is properly con-
nected to the socket.
Charging connector is not securely con-
nected to AC charging inlet
Check the connection status of the
charging connector.
When connecting the charging con-
nector, insert the charging connector
securely.
After connecting the charging connec-
tor, check that the charging indicator of
the charging port is turned on.
If the charging indicator of the charging
port does not illuminate, even though the
charging connector is securely con-
nected, there may be a malfunction in the
system. Immediately stop charging and
contact any authorized Toyota retailer or
Toyota authorized repairer, or any reli-
able repairer.
Hybrid battery (traction battery) is
already fully charged
When the hybrid battery (traction battery)
is fully charged, charging is not per-
formed.
The charger does not operate
Please contact the facility manager when
there is a problem with charger.
To Next Page
Loading...
