172
2-2. Charging
■ Charging does not start, even though it is time set in “Start” or
“Start at set time”
When a door is opened with the
power switch off, after charging, a
message is displayed in the multi-
information display.
When this occurs, follow the instruc-
tions displayed on the screen.
■ If “Charging Stopped Due to Pulled Charging Connector” is shown
Likely cause Correction procedure
AC charging cable was connected after
set time
Connect the AC charging cable before
the time set in “Start” or “Start at set
time”.
When charging-related message is displayed
Likely cause Correction procedure
Charging connector is removed while
charging
When the charging connector is removed
while charging, charging stops. If you
want to fully charge the hybrid battery
(traction battery), reconnect the charging
connector.
After the hybrid battery (traction battery)
is fully charged, the charging connector
is removed while the hybrid battery (trac-
tion battery) is being recharged again
because electricity-consuming func-
tions
*
have been used and the remaining
charge is now reduced.
To Next Page
Loading...
