246
4-2. Opening, closing and locking the doors
OFF, the light will go off automatically
after 20 minutes.
■ Back door closer
In the event that the back door is left
slightly open, the back door closer will
automatically close it to the fully closed
position.
Whatever the state of the power switch,
the back door closer operates.
■ Power back door operating condi-
tions
The power back door can automatically
open and close under the following con-
ditions:
● When the power back door system is
enabled. (P.206)
● When the back door is unlocked.
However, if the back door opener switch
is pressed and held while carrying the
electronic key on your person, the
power back door will be operated even if
the back door is locked. (P.244)
● When the power switch is in ON, in
addition to the above for the opening
operations, the back door operates for
any of the following conditions:
• Parking brake is engaged
• The brake pedal is depressed
• The shift lever is in P.
■ Operation of the power back door
● A buzzer sounds to indicate that the
back door is opening/closing.
● When the power back door system is
disabled, the power back door does
not operate but it can be opened and
closed by hand.
● When the power back door automati-
cally opens, if an abnormality due to
people or objects is detected, opera-
tion will stop.
■ Jam protection function
Sensors are equipped on both sides of
the power back door. If anything
obstructs the power back door while it is
closing, the back door will automatically
operate in the opposite direction or stop.
■ Fall-down protection function
While the power back door is opening
automatically, applying excessive force
to it will stop the opening operation to
prevent the power back door from sud-
denly shutting.
■ Back door closing assist
If the back door is lowered manually
when the back door is stopped at an
open position, the back door will fully
close automatically.
■ Back door reserve lock function
This function is a function which
reserves locking of all doors, before-
hand, when the power back door is
open.
When the following procedure is per-
formed, all the doors except the power
back door are locked and then power
back door will also be locked at the
same time it is closed.
1 Close all doors, except the back
door.
2 During the power back door closing
operation, lock the doors using the
smart entry & start system from the
front doors (P.235) or the wireless
remote control. (P.235)
Operation signals will indicate that all
the doors have been closed and locked.
(P.236)
● If the electronic key is placed inside
the vehicle after starting a close oper-
ation via the door reserve lock func-
tion, the electronic key may become
locked inside the vehicle.
● If the power back door does not fully
close due to the operation of the jam
protection function, etc., while the
back door is automatically closing
To Next Page
Loading...
