262
4-3. Adjusting the seats
will be overwritten.
■ Recall procedure
1 Check that the shift lever is in P.
2 Turn the power switch to ON.
3 Press one of the buttons for the
driving position you want to
recall until the buzzer sounds.
■ To stop the position recall opera-
tion part-way through
Perform any of the following:
● Press the “SET” button.
● Press button “1” or “2”.
● Operate any of the seat adjustment
switches.
■ Seat positions that can be memo-
rized (P.258)
The adjusted positions other than the
position adjusted by lumbar support
switch can be recorded.
■ Operating the driving position
memory after turning the power
switch to OFF
Recorded seat positions can be acti-
vated up to 180 seconds after the
driver’s door is opened and another 60
seconds after it is closed again.
■ In order to correctly use the driving
position memory function
If a seat position is already in the fur-
thest possible position and the seat is
operated in the same direction, the
recorded position may be slightly differ-
ent when it is recalled.
■ When recalling the driving position
Take care when recalling the driving
position so that the head restraint does
not touch the ceiling.
■ If the 12-volt battery is discon-
nected
The memorized positions are erased.
■ When the recorded seat position
cannot be recalled
The seat position may not be recalled in
some situations when the seat position
is recorded in a certain range. For
details, contact any authorized Toyota
retailer or Toyota authorized repairer, or
any reliable repairer.
■ Registering procedure
Record your driving position to but-
■ Seat adjustment caution
Take care during seat adjustment so
that the seat does not strike the rear
passenger or squeeze your body
against the steering wheel.
Registering/recall/canceling
an electronic key to driving
position (memory recall
function)
To Next Page
Loading...
