373
5
5-5. Using the driving support systems
Driving
2 Accelerate or decelerate, with
accelerator pedal operation, to
the desired vehicle speed (at or
above approximately 30 km/h
[20 mph]) and press the “-SET”
switch to set the speed.
Cruise control “SET” indicator will come
on.
The vehicle speed at the moment the
switch is released becomes the set
speed.
Vehicles with 7-inch multi-infor-
mation display
Vehicles with 12.3-inch multi-
information display
Adjusting the set speed by the
switch
To change the set speed, press the
“+RES” or “-SET” switch until the
desired set speed is displayed.
1 Increases the speed (Except
when the vehicle has been
stopped by system control in
vehicle-to-vehicle distance con-
trol mode)
2 Decreases the speed
Fine adjustment: Press the switch.
Large adjustment: Press and hold the
switch to change the speed, and
release when the desired speed is
reached.
In the vehicle-to-vehicle distance
control mode, the set speed will be
increased or decreased as follows:
Fine adjustment: By 1 km/h (0.6 mph)
*1
or 1 mph (1.6 km/h)
*2
each time the
switch is pressed
Large adjustment: Increases or
decreases in 5 km/h (3.1 mph)
*1
or 5
mph (8 km/h)
*2
increments for as long
as the switch is held
In the constant speed control mode
(P.377), the set speed will be
increased or decreased as follows:
Fine adjustment: By 1 km/h (0.6 mph)
*1
or 1 mph (1.6 km/h)
*2
each time the
switch is pressed
Large adjustment: The speed will con-
tinue to change while the switch is held.
Adjusting the set speed
A
B
To Next Page
Loading...
