383
5
5-5. Using the driving support systems
Driving
the “+RES” or “-SET” switch until
the desired set speed is obtained.
1 Increases the speed
2 Decreases the speed
Fine adjustment: Press the switch.
Large adjustment: Press and hold the
switch to change the speed, and
release when the desired speed is
reached.
The set speed will be increased or
decreased as follows:
Fine adjustment: By 1 km/h (0.6
mph)
*1
or 1 mph (1.6 km/h)
*2
each
time the switch is operated.
Large adjustment: The set speed
can be increased or decreased
continually until the switch is
released.
*1
: When the set speed is shown in
“km/h”
*2
: When the set speed is shown in
“MPH”
1 Pressing the cancel switch can-
cels the constant speed control.
The speed setting is also canceled
when the brakes are applied.
2 Pressing the “+RES” switch
resumes the constant speed
control.
Resuming is available when the vehicle
speed is more than approximately 30
km/h (20 mph).
■ Cruise control can be set when
● The shift lever is in D.
● Vehicle speed is above approximately
30 km/h (20 mph).
■ Accelerating after setting the vehi-
cle speed
● The vehicle can be accelerated nor-
mally. After acceleration, the set
speed resumes.
● Even without canceling the cruise
control, the set speed can be
increased by first accelerating the
vehicle to the desired speed and then
pushing the “-SET” switch to set the
new speed.
■ Automatic cancelation of cruise
control
Cruise control will stop maintaining the
vehicle speed in any of the following sit-
Canceling and resuming the
constant speed control
To Next Page
Loading...
