388
5-5. Using the driving support systems
■ Outside rear view mirror indicators
visibility
In strong sunlight, the outside rear view
mirror indicator may be difficult to see.
■ Hearing the RCTA buzzer
The RCTA buzzer may be difficult to
hear over loud noises such as high
audio volume.
■ When “Blind Spot Monitor Unavail-
able” or “RCTA Unavailable” is
shown on the multi-information
display
The sensor voltage has become abnor-
mal, or water, snow, mud, etc., may be
built up in the vicinity of the sensor area
of the rear bumper. (P.388)
Removing the water, snow, mud, etc.,
from the vicinity of the sensor area
should return it to normal.
Also, the sensor may not function nor-
mally when used in extremely hot or
cold weather.
■ When “Blind Spot Monitor Malfunc-
tion Visit Your Dealer” or “RCTA
Malfunction Visit Your Dealer” is
shown on the multi-information
display
There may be a sensor malfunction or
misaligned. Have the vehicle inspected
at any authorized Toyota retailer or
Toyota authorized repairer, or any reli-
able repairer.
■ Customization
Some functions can be customized.
(P.206, 217)
■ To ensure the system can oper-
ate properly
Blind Spot Monitor sensors are
installed inside the left and right sides
of the rear bumper respectively.
Observe the following to ensure the
Blind Spot Monitor can function cor-
rectly.
● Keep the sensors and the sur-
rounding areas on the rear bumper
clean at all times.
If a sensor or its surrounding area
on the rear bumper is dirty or cov-
ered with snow, the Blind Spot
Monitor may not operate and a
warning message (P.388) will be
displayed. In this situation, clear off
the dirt or snow and drive the vehi-
cle with the operation conditions of
the BSM function (P.390) satis-
fied for approximately 10 minutes. If
the warning message does not dis-
appear, have the vehicle inspected
by any authorized Toyota retailer or
Toyota authorized repairer, or any
reliable repairer.
To Next Page
Loading...
