397
5
5-5. Using the driving support systems
Driving
To re-enable the system, select on
the multi-information display, select
and turn it on.
If the system is disabled, it will remain
off even if the power switch is turned to
ON after the power switch has been
turned off.
■ The system can be operated when
● The power switch is in ON.
● Toyota parking assist-sensor function
is on.
● The vehicle speed is less than about
10 km/h (6 mph).
● The shift lever is in other than P.
■ If “Clean Parking Assist Sensor” is
displayed on the multi-information
display
A sensor may be covered with ice,
snow, dirt, etc. Remove the ice, snow,
dirt, etc., from the sensor to return the
system to normal.
Also, due to ice forming on a sensor at
low temperatures, a warning message
■ Cautions regarding the use of
the system
There is a limit to the degree of recog-
nition accuracy and control perfor-
mance that this system can provide,
do not overly rely on this system. The
driver is always responsible for pay-
ing attention to the vehicle’s sur-
roundings and driving safely.
■ To ensure the system can oper-
ate properly
Observe the following precautions.
Failing to do so may result in the vehi-
cle being unable to be driven safely
and possibly cause an accident.
● Do not damage the sensors, and
always keep them clean.
● Do not attach a sticker or install an
electronic component, such as a
backlit license plate (especially fluo-
rescent type), fog lights, fender pole
or wireless antenna near a radar
sensor.
● Do not subject the surrounding area
of the sensor to a strong impact. If
subjected to an impact, have the
vehicle inspected by any authorized
Toyota retailer or Toyota authorized
repairer, or any reliable repairer. If
the front or rear bumper needs to
be removed/installed or replaced,
contact any authorized Toyota
retailer or Toyota authorized
repairer, or any reliable repairer.
● Do not modify, disassemble or paint
the sensors.
● Do not attach a license plate cover.
● Keep your tires properly inflated.
■ When to disable the function
In the following situations, disable the
function as it may operate even
though there is no possibility of a colli-
sion.
● Failing to observe the warnings
above.
● A non-genuine Toyota suspension
(lowered suspension, etc.) is
installed.
■ Notes when washing the vehicle
Do not apply intensive bursts of water
or steam to the sensor area.
Doing so may result in the sensor
malfunctioning.
● When using a high pressure
washer to wash the vehicle, do not
spray the sensors directly, as doing
so may cause a sensor to malfunc-
tion.
● When using steam to clean the
vehicle, do not direct steam too
close to the sensors as doing so
may cause a sensor to malfunction.
To Next Page
Loading...
