64
1-2. Child safety
seat, if there is a gap between
the child seat and the seatback,
adjust the seatback angle until
good contact is achieved.
2 If the head restraint interferes
with the child restraint system
installation and the head
restraint can be removed,
remove the head restraint. Oth-
erwise, put the head restraint in
the upper most position.
(P.264)
3 Check the positions of the exclu-
sive fixing bars, and install the
child restraint system to the
seat.
The bars are installed in the clearance
between the seat cushion and seat-
back.
4 After installing the child restraint
system, rock it back and forth to
ensure that it is installed
securely. (P.63)
■ Top tether anchorages
Top tether anchorages are pro-
vided for the outboard rear seats.
Use top tether anchorages when
fixing the top strap.
Top tether anchorages
Top strap
■ Fixing the top strap to the top
tether anchorages
Install the child restraint system in
■ When installing a child restraint
system
Observe the following precautions.
Failure to do so may result in death or
serious injury.
● After securing a child restraint sys-
tem, never adjust the seat.
● When using the lower anchorages,
be sure that there are no foreign
objects around the anchorages and
that the seat belt is not caught
behind the child restraint system.
● Follow all installation instructions
provided by the child restraint sys-
tem manufacturer.
Using a top tether anchor-
age
A
B
To Next Page
Loading...
