81
1
1-4. Theft deterrent system
For safety and security
the alarm, as they will respond to
movement inside the vehicle.
1 Turn the power switch to OFF.
2 Press the intrusion sensor and
tilt sensor cancel switch.
Press the switch again to re-enable the
intrusion sensor and tilt sensor.
Each time the intrusion sensor and tilt
sensor are canceled/set, a message
will be shown on the multi-information
display.
■ Canceling and automatic re-
enabling of the intrusion sensor
and tilt sensor
● The alarm will still be set even when
the intrusion sensor and tilt sensor are
canceled.
● After the intrusion sensor and tilt sen-
sor are canceled, pressing the power
switch or unlocking the doors using
the entry function or wireless remote
control will re-enable the intrusion
sensor and tilt sensor.
● The intrusion sensor and tilt sensor
will automatically be re-enabled when
the alarm system is reactivated.
■ Intrusion sensor detection consid-
erations
The sensor may trigger the alarm in the
following situations:
● People or pets are in the vehicle.
● A side window or panoramic moon
roof (if equipped) is open.
In this case, the sensor may detect the
following:
• Wind or the movement of objects such
as leaves and insects inside the vehi-
cle
• Ultrasonic waves emitted from
devices such as the intrusion sensors
of other vehicles
• The movement of people outside the
vehicle
● Unstable items, such as dangling
accessories or clothes hanging on the
coat hooks, are in the vehicle.
● The vehicle is parked in a place where
extreme vibrations or noises occur,
such as in a parking garage.
To Next Page
Loading...
