Instruction
Form：DP5-005 Revised：05 26
3.7 Rewriting Program
Refer to the "Firmware programming manual" for the reprogramming procedure of wireless ST
reprograming.
<Operation of the VIM reprogram switch>
Slide the switch using a small screw driver (minus), etc.
After program rewriting is completed, Shift switch option to [Run] (Left) by screwdriver (Minus
type).
CAUTION
Handle the switch carefully.
●There is a possibility that the sharp portion causes injury.
Reprogram switch is [PRG] side.
RUN
PRG
Small screw driver (Minus type)
Rreprogram switch is [RUN] side.
RUN
PRG
To Next Page
Loading...
