EasyManuals Logo

TP-Link AC1350 User Manual

TP-Link AC1350
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
73
Chapter 13
Customize Your Network Settings
13. 3. Specify DHCP Server Settings
By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and
the router acts as a DHCP server; it dynamically assigns TCP/IP parameters to client
devices from the IP Address Pool. You can change the settings of the DHCP Server if
necessary, and you can reserve LAN IP addresses for specified client devices.
1. Visit
http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2. Go to
Advanced > Network > DHCP Server.
¾ To specify the IP address that the router assigns:
1. Tick the Enable DHCP Server checkbox.
2. Enter the starting and ending IP addresses in the
IP Address Pool.
3. Enter other parameters if the ISP offers. The
Default Gateway is automatically filled in
and is the same as the LAN IP address of the router.
4. Click
Save.
¾ To reserve an IP address for a specified client device:
1. Click
Add in the Address Reservation section.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TP-Link AC1350 and is the answer not in the manual?

TP-Link AC1350 Specifications

General IconGeneral
Frequency Band2.4 GHz and 5 GHz
Antenna3x External Antennas
Wireless Security64/128-bit WEP, WPA/WPA2, WPA-PSK/WPA2-PSK
Wireless StandardIEEE 802.11ac/n/a 5 GHz, IEEE 802.11b/g/n 2.4 GHz
Wi-Fi Speed867 Mbps at 5 GHz, 450 Mbps at 2.4 GHz
USB Port1 x USB 2.0
Security FeaturesAccess Control
Dimensions243 x 160.6 x 32.5 mm

Related product manuals