68
Chapter 12
Manage the Router
1. Tick the Enable checkbox of Remote Management.
2. Keep the HTTPS and HTTP port as default settings (recommended) or enter a value
between 1024 and 65535.
3. Select
Specified Device for Remote Managers.
4. In the
Only this IP Address field, enter the IP address of the remote device to manage
the router.
5. Click
SAVE.
Devices using this WAN IP can manage the router by logging in to
http://Router’s WAN
IP:port number
(such as http://113.116.60.229:1024).
Tips: The router’s WAN IP is usually a dynamic IP. Please refer to Set Up a Dynamic DNS Service Account if you want
to log in to the router through a domain name.
12. 6. View System Log
When the router does not work normally, you can save the system log and send it to the
technical support for troubleshooting.
1. Visit
http://tplinkwifi.net, and log in your TP-Link ID or the password you set for the
router.
2. Go to
Advanced > System > System Log.
3. In the
Save Log section, click SAVE TO LOCAL to save the system logs to a local disk.
To Next Page
Loading...
