27
Chapter 6
USB Application
6. 1. 2. Customize Your Settings
¾ To Only Share Specific Content
By default, Share All is enabled so all of the content on the USB disk is shared. If you
want to only share specific folders, follow the steps below:
1. Visit http://tplinkwifi.net, then log in with the username and password you set for the
router.
2. Go to Basic > USB Settings > Sharing Access. Focus on the Folder Sharing section.
Click the button to disable Share All, and then click Add to add a new sharing folder.
3. Select the Volume Name and Folder Path, and then enter a Folder Name as you like.
4. Decide the way you share the folder:
• Allow Guest Network Access: If you tick this check box, guest network users
can access the folder.
• Enable Authentication: If you tick this check box, you will be required to use a
username and password to access the folder. Refer to To Set up Authentication
for Data Security to learn more.
• Enable Write Access: If you tick this check box, network clients can modify the
folder.
• Enable Media Sharing: If you tick this check box, you can view photos, play
music and watch movies in the folder directly from DLNA-supported devices.
Click Media Sharing to learn more.
5. Click OK.
To Next Page
Loading...
