TP-Link CPE210 - Page 11

07
r0RXQWLQJ&3(
$WWKHVHOHFWHGVLWHDSSUR[LPDWHO\DOLJQWKH&3(WRWKHGLUHFWLRQWKDW\RX
have oriented.
r0RXQWLQJ3RZHU$GDSWHU2SWLRQDO
Follow the steps below to mount the power adapter:
7RHQVXUHWKHSDVVLYH3R(DGDSWHULVDWWDFKHGPRVWVHFXUHO\LWLV
recommended to install the adapter with the Ethernet port facing upward.
1. Drill two holes on the wall and insert the plastic wall anchors into
the holes. Secure the mounting bracket to the wall. Make sure the
shoulders at the corners of the mounting bracket are on the outside
and pointing upward.
 Attach the passive PoE adapter to the mounting bracket by sliding
the adapter in the direction of the arrows until it locks into place.